Standard and customized aluminum rails by TECAM
P-272 Low Profile and P-252 Surface aluminum rails
Standard or custom aluminum rails
ADVANTAGES:
- Universal machined rails made of high-alloy aluminum and reinforced in critical areas.m
- Pre-drilled according to test protocol (M8 countersunk bolts or with rivets).
- On request, rails can be supplied with machining at different formats and sizes or without drilling.
- Standard length: 3660mm. Also available 6000mm or special length.
Low-profile rail:
- Suitable for installation in new construction vehicles.
- Anodized finish as standard.
- Equipped with side tabs designed to adjust to the floor level, achieving a minimal protrusion, giving a uniform and clean appearance.
Surface Rails:
- Designed to be installed on the vehicle floor.
- To be used used in vehicles that already have a bodywork or when the installation of the recessed rail is not feasible for technical or economic reasons. for technical or economic reasons is not feasible.
Rubber Rail Cover and End Caps
End cap for aluminum rails: P-374 & P-375
ADVANTAGES:
- Designed to fit the ends of our low-profile and surface rails.
- Improve vehicle floor finish
- Made of aluminum.
Rubber cover for aluminium rails - P-372
ADVANTAGES:
- This rubber cover is easily inserted into the rails channel.
- Prevents the accumulation of dirt and improves the appearance of the vehicle floor.
- Supplied in the required length.
- Applicable to both low-profile and surface rails.
